Model: |
P2H-5400V |
Output Wattage: |
400W |
Dimension: |
(D × W × H) 215 × 100 × 70(mm) |
|
|
AC Input Spec. |
VOLTAGE: 100~240 VAC FULL RANGE
FREQUENCY: 47~63HZ
INPUT CURRENT:6A (RMS) FOR 115 VAC/
3A (RMS) FOR 230 VAC
INRUSH CURRENT:40A MAX. FOR 115 VAC/
60A MAX. FOR 230 VAC |
DC Output Spec. |
Output VoltageTD |
Output Current Min. |
Output Current Max. |
Regulation Load |
Regulation Line |
Output Ripple & Noise Max.[P-P] |
+5V |
1 |
22 |
±5% |
±1% |
70mV |
+12V |
1 |
32 |
±5% |
±1% |
120mV |
-12V |
0.1 |
0.8 |
±10% |
±1% |
120mV |
+3.3V |
1 |
22 |
±5% |
±1% |
70mV |
+5VSB |
0.1 |
3.3 |
±5% |
±1% |
70mV |
|
|
Features |
* TEMPERATURE RANGE:OPERATING 0℃~40℃
* HOLD UP TIME:16mS MINIMUM AT FULL LOAD & NOMINAL INPUT VOLTAGE
* DIELECTRIC WITHSTAND:INPUT/OUTPUT 1800 VAC FOR 1 SECOND INPUT TO FRAME GROUND 1800 VAC FOR 1 SECOND
* EFFICIENCY:83% TYPICAL AT 115VAC , FULL LOAD
* POWER GOOD SIGNAL:ON DELAY 100mS TO 500mS,OFF DELAY 1mS
* OVER POWER PROTECTION:110~160% MAX
* OVER VOLTAGE PROTECTION:+5V→5.6V~6.6V +3.3V→3.6V~4.3V +12V→13.2V~15V
* SHORT CIRCUIT PROTECTION:+5V、+12V、+3.3V
* EMI NOISE FILTER : FCC CLASS A, CISPR22 CLASS A
* SAFETY : TO MEET UL, CUL, TUV
* REMOTE ON/OFF CONTROL THE POWER SUPPLY SHALL ACCEPT A LOGIC OPEN COLLECTOR LEVEL WHICH WILL DISABLE/ENABLE ALL THE OUTPUT VOLTAGE (EXCLUDE +5V STAND BY). AS LOGIC LEVEL IS LOW,OUTPUTS VOLTAGE WERE ENABLE, AS LOGIC LEVEL IS HIGH,OUTPUTS VOLTAGE WERE DISABLE.
* 3.3V & 5V REMOTE SENSING
* COOLING: ONE 40mm DC FANS
* MEET IEC-1000-3-2 CLASS D
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS. |
Connector Configuration |
Connector |
20 plus 4 pin ATX main power cable |
8 pin EPS plus 12 volt power cable |
4 plus 4 pin plus 12 volt power cable |
SATA power cable |
4 pin peripheral power cable |
Quantity |
1 |
1 |
1 |
2 |
1 |
|