    
| Model: |
P1U-6250P |
| Output Wattage: |
250W |
| Dimension: |
190x100x40(mm), 7.48x3.94x1.57(inch) |
|
|
| AC Input Spec. |
VOLTAGE: 100 ~ 240 VAC FULL RANGE
FREQUENCY : 47 ~ 63 HZ
INPUT CURRENT: 4~2 AMPS MAXIMUM AT ANY LOW/HIGH
RANGE INPUT VOLTAGE.
INRUSH CURRENT: 65/130 AMPS @110/220 VAC
(AT 25 DEGREES AMBIENT COLD START) |
| DC Output Spec. |
| Output VoltageTD |
Output Current Min. |
Output Current Max. |
Regulation Load |
Regulation Line |
Output Ripple & Noise Max.[P-P] |
| 5V |
2 |
16 |
± 5% |
± 1% |
70mV |
| +12V |
1 |
16 |
± 5% |
± 1% |
120mV |
| -5V |
0.1 |
0.2 |
± 5% |
± 1% |
100mV |
| -12V |
0.1 |
0.7 |
-10%~+10% |
± 1% |
120mV |
| +3.3V |
1 |
14 |
± 5% |
± 1% |
70mV |
| +5VSB |
0.1 |
1.5 |
± 5% |
± 1% |
70mV |
REMARKS:
1. THE OUTPUT POWER OF +5V & +3.3V NOT EXCEED 110 WATTS
2. +5V,+3.3V AND +12V TOTAL OUTPUT MAX: 236W
3. +3.3V CURRENT DERATING LINEARLY TO 10A AT 45℃
|
|
Features
* TEMPERATURE RANGE: OPERATING 0℃ ~ 45℃, STORAGE -20℃~80℃
* EFFICIENCY: POWER SUPPLY EFFICIENCY TYPICAL 65% AT 115V，FULL LOAD.
* HOLD UP TIME: WHEN POWER SHUTDOWN DC OUTPUT 5V MUST BE MAINTAIN 16MSEC IN REGULATION LIMIT AT NORMAL INPUT VOLTAGE
* HUMIDITY:OPERATING:20%-80%, NON-OPERATING:10%-90%
* REMARKS:85% IS NORMAL CONDITION AND 95% IS WITH SPECIAL COATING PROCESS
* OVER POWER PROTECTION: 110~160%
* OVER VOLTAGE PROTECTION: +5V ：5.6V ∼ 6.6V, +3.3V ：3.6V ∼ 4.2V, +12V ：13.2V ∼ 14.6V
* SHORT CIRCUIT PROTECTION
* LEAKAGE CURRENT: 3.5 MA. MAX. AT NOMINAL VOLTAGE 250 VAC
* SAFETY: TO MEEET UL, CUL, TUV
* REMOTE ON/OFF CONTROL
*THE POWER-SUPPLY IS FOR CHASSIS-ASSEMBLY ONLY AND IS NOT ALLOWED TO BE OPERATED AS STAND-ALONE COMPONENT. FINAL ASSEMBLY HAS TO COMPLY WITH CORRESPONDING EMC- AND SAFETY-REGULATIONS.
|
| Connector Configuration |
| Connector |
20 + 4 pin ATX main power cable |
8 pin EPS plus 12 volt power cable |
Floppy drive power cable |
SATA power cable |
4 pin peripheral power cable |
| Quantity |
1 |
1 |
1 |
2 |
1 |
|
